Delay And Insert Parameters - Studer Vista 1 Operating Instructions Manual

Vista 1 Digital Mixing System
3.3.7

Delay and insert Parameters

delay Parameters:
DELAY On/Off
deLaY Rotary
deLaY time/smpl
3-14 Parameters
Press GLOBAL VIEW: DLY-INS.
This view enables the user to control the delay and insert parameters.
Please note: The two sections are activated with the DELAY and INS hardware
keys above the Vistonics section.
For 5.1 channels the delay processing block has a maximum delay time of
700 ms (as opposed to the standard 240 or 100 ms delay in the mono or stereo
channels).
The delay value is set using the rotary encoder. It is displayed as a physical
distance (meters) and as a delay time (either samples or milli-seconds).
is selected with the DELAY hardware key above the Vistonics section.
Delay time can be set in a range from 0 through 100 ms (or, depending on
the currently loaded configuration, to a maximum of 240 ms). The value is
displayed as a delay distance as well (from 0 cm up to 81.5 m, depending on
the configuration).
Selects the delay setting in samples ('smpl' – fine setting) or milli-seconds
('time' – coarse setting).
SW V5.3 Document generated: 18.04.17