Studer Vista 1 Operating Instructions Manual page 92

Vista 1 Digital Mixing System
2-52 Desk Operation
A master is released out of Follow Solo as soon one of the following criteria
is met :
• The PFL resp. SOLO key is pressed again.
• The PFL resp. SOLO key of a different master channel is pressed.
• The CLR key in the monitoring section is pressed.
• Through section navigation, the master channel is not on the desk surface
anymore, and therefore the flashing key is not visible anymore.
• The Follow Solo Mode is being disabled in the GC General Ribbon.
Assign
Further to showing the contribution levels on the faders, Follow Solo also pro-
vides a new tool for bus assigning (or Aux On/Off). With a master in Follow
Solo, an Assign button is displayed in the Label Area of each channel strip.
By touching this Assign button, the chosen channel can directly be assigned/
unassigned to/off the master bus. The Assign button shows the state of bus
assign in the same graphical language that the "normal" bus assign view uses.
Ganging of several channels can be used to assign many channels at once.
SW V5.3 Document generated: 18.04.17