Studer Vista 1 Operating Instructions Manual page 318

Vista 1 Digital Mixing System
Panel Selection box:
Key Selection box:
Display Name entry box:
Speaker/Source Selection entry boxes:
Clear Selection button:
Source Type Selection box:
4-142 GC Operation
display the name and location of the currently loaded monitor configuration.
This box provides a pop-up menu used to select a control room or studio
Assignable Source Selector panel installed in the control surface for editing.
The Source Selector keys for the selected panel will be displayed in the Keys
box, where they can be selected for editing. The name of the panel may also
be edited using this box.
Note: The four subpanels popping up on the screen upon activated option (experts
only!) show up as individual panels with 12 source selectors each.
This box is used to select a specific Monitor Source Selector key for editing.
This is a name entry box for the selected Source Selector key. It will display
the name of the selected key, which can be edited.
These fields are used to connect a digital audio source (such as a direct output)
to a specific loudspeaker feed (such as left, right, center, etc.). This is accom-
plished by highlighting a source from the Source Selection list and assigning
it to the desired loudspeaker feed using the appropriate double-arrow button
(<<). When such an assignment is made, the source name will appear in the
selected loudspeaker field. Selections may be cleared using the X buttons.
This button will clear all Speaker/Source selections made for that Monitor
Source Selector key.
This box provides a pop-up menu used to select the type of digital source for
assignment (such as a mono master direct output or an AES interface). Once
an item has been selected, all the sources of that type will be displayed in the
Sources list below.
SW V5.3 Document generated: 18.04.17