Studer Vista 1 Operating Instructions Manual page 226

Vista 1 Digital Mixing System
Audio Settings:
Input/Bus Assign Settings:
General Patch Setting:
User Labels:
4-50 GC Operation
This window allows adding a whole group of parameters to your snapshot
filter. Either select one of the four groups on top, or one of the listed busses.
Will add all channel processing functions to your snapshot filter.
Will add the input switches of all channels as well as all bus assignments to
your snapshot filter.
Will add the General Patch to your snapshot filter, meaning that no patch
points will change when recalling a snapshot.
Will add all user labels (within the General Patch as well as within the channel
strips) to the snapshot filter.
Bus:
This is a very powerful feature. By clicking e.g. on 'Aux m 1', you will add
all relevant parameters to your snapshot filter, such that the Mono AUX Bus 1
will not be influenced by any snapshot recalling. Included are:
• The levels of all channels routed onto that bus
• The bus assign (on/off switch) of all channels for that bus
• The corresponding master channel with all its settings
• The output patch made from that master channel to any output ports.
Caution:
Clicking on the 'Clear All' button will completely remove the snapshot filter
and therefore may change all console parameters upon the next snapshot
recall.
Clicking on the 'Mask All' button will protect the whole console (with some
exceptions, such as Patch points) against snapshot recalls, afterwards allo-
wing to enable just single elements to be activated.
SW V5.3 Document generated: 18.04.17