Talkback Control - Studer Vista 1 Operating Instructions Manual

Vista 1 Digital Mixing System
2.2.5.8

talkback Control

 TALKBACK
 AUX 1...4 STEREO
2-32 Desk Operation
Whenever TALK is pressed, the signal from the talkback microphone input is
fed to the corresponding group.
The talkback input usually is microphone input no. 32. It is pre-configured
but not activated, refer to
Note: The talkback signal is inserted directly before the output interface of the
core. If signals are routed internally to some other destinations, the talkback
will not harm them.
Available talk destinations:
AUX
Direct outputs of all AUX masters
GRP
Direct outputs of all group masters
MAST
Direct outputs of all masters
DIR
Direct outputs of all input channels
BUS
Outputs of all multi-track buses (without faders in between)
STUDIO
Talkback to both Studio A and B simultaneously).
For talking to headphone mixes, these keys can be used to directly activate
talkback to the corresponding AUX master outputs.
A talkback and signaling block diagram is shown on the next page.
SW V5.3
chapter 2.1.5.
Document generated: 18.04.17