Filter Parameters - Studer Vista 1 Operating Instructions Manual

3.3.6

Filter Parameters

hI CUT/Lo CUT x dB
hI CUT/Lo CUT Rotary
Document generated: 18.04.17
Press GLOBAL VIEW: FILTER.
This view enables the user to control the parameters of the hi- and low-cut
filters. These filters are available on the channel-related EQ view as well,
refer to chapter 3.4.1. In that chapter you will also find the parameter details.
The two filter sections are activated with the HI CUT and LO CUT hardware
keys above the Vistonics section.
For 5.1 surround channels, the high- and low-cut filter parameters applied here
are valid for all surround signal legs, except the LFE. For further information
on this subject, please refer to
Slope setting for the high- and low-cut filters, selectable from 12, 18, and
24 dB/octave (key toggles 12, 18, 24, 12...).
Cutoff frequency adjustment for both the high- and low-cut filters: 20 Hz
through 20 kHz, in 120 steps.
SW V5.3
Vista 1 Digital Mixing System
chapter 3.4.1.
Parameters 3-13