Studer Vista 1 Operating Instructions Manual page 291

Signal Out Configuration
Document generated: 18.04.17
This action will open the Edit relay labels page and first allow selection of
the desired relay, and then to enter a user label for each relay. Be sure to click
ok when finished; otherwise all changes will be lost.
The fixed relay labels have been automatically generated by the Vista
system. They have the format SIGOUT0_REL01, where SIGOUT0,
SIGOUT1, etc. define the relay card number, and REL01, REL02, etc.
define the relay number on a particular card.
There are 16 relays per card. Some of the physically present relays may be
assigned to internal system functions and may therefore not be available for
the Signaling Configuration.
Source labels can be edited in the Patch pages; refer to
4.4.3.
Signaling Outputs are generally relay contacts installed in the monitoring
frame. They may be used for various purposes, such as:
• Fader Start
• Microphone ON actions (loudspeaker muting, etc)
• Parallel Record/Ready mode of DAW tracks.
Up to four different relays may be configured for each source. They may fea-
ture different Trigger Setups (see later). For each relay, Latching or Impulse
SW V5.3
Vista 1 Digital Mixing System
chapters 4.4.2
GC Operation 4-115
and