Panning Parameters For 5.1 Surround Channels - Studer Vista 1 Operating Instructions Manual

Vista 1 Digital Mixing System
3.4.4.5

Panning Parameters for 5.1 surround Channels

General PAN on/off
CenT LeVeL
FRonT L-R Front panning between the left, (center) and right channels in 1° steps. The
ReaR L-R Panning between the left and right surround channels in 1° steps.
PanaRnd on/off
PanaRnd
LFe on/off
LFe LeVeL
3-46 Parameters
Touch the yellow Vistonics pan field.
is selected with the PAN hardware key above the Vistonics section.
Center level control from MUTE (i.e. –∞ dB) to +10 dB.
FB on/off
On/off switch for center channel contribution to the F-R control.
contribution to the center channel is determined by the CENTER control.
F-R
This parameter allows variable blending from front to rear channels in 60
increments, either with a contribution from the center channel (FB On) or
without (FB Off).
Activates the Pan-Around function.
Single-knob function, allows rotating the surround sound field by ±180°.
On/off selector for LFE channel use.
LFE channel percentage control; 0% = no LFE channel use, 100% = LFE
channel fully active.
SW V5.3 Document generated: 18.04.17