Stereo Aux Parameters - Studer Vista 1 Operating Instructions Manual

Vista 1 Digital Mixing System
3.3.5

stereo AUX Parameters

aux s x on/off
aux s x Rotary
aUX s x Pre/Post
aUX s x Pan Rotary
aUX s x Follow on/off
3-12 Parameters
Press one of the GLOBAL VIEW: AUX STEREO keys.
The stereo AUX view provides selection of the AUX bus (ON/OFF), send
level adjustment, pre-/after-fader switching, and pan setting. From 5.1 sur-
round channels, stereo AUX sends are fed with an ITU-compatible stereo
down-mix.
Stereo AUX bus selection. Other stereo AUX bus views can be selected as
well, if provided by the currently loaded configuration (5...8, 9...12, etc.).
The send levels for stereo AUX busses can be adjusted using this rotary
encoder; adjustment range is from MUTE (i.e. –∞) through +10 dB.
When the PRE / POST key in the fader bay's GLOBAL VIEW area is active,
the Vistonics view changes similar to the one shown above in the center. The
signal sent to the stereo AUX bus can be selected from PRE (pre-fader, i.e.
before the fader) or POST (post-fader, i.e. after the fader).
The Stereo Aux Pan view is activated by pressing the PAN key below the
GLOBAL VIEW - AUX keys. By default, the Aux panner is linked to the channel
pan value (Follow On), as shown above at the right. If the channel panning
is 'multi-format', only the L/R setting is used for the Aux pan.
If individual Aux pan settings are required, the default setting ('Follow On',
i.e. the Aux pan setting follows the channel pan) may be switched off; the
Aux panner is then adjusted with the Vistonics rotary encoder.
SW V5.3 Document generated: 18.04.17