Table of Contents
Advertisement
4.4.3.5
Set the Metering and Direct out Source Point
Set Metering Source Point:
Set Direct Output source Point:
4.4.3.6
Switch off the label inheritance
Document generated: 18.04.17
To set the Metering Source point in the selected channel's audio path, click
on one of the three Meter boxes. The channel meter will now be sourced from
the selected point in the signal path.
Available points in the signal path are:
•
After Input Block;
•
After Fader & Mute;
•
After Direct Out level control.
The Meter Source point is saved within snapshots and presets.
Note:
There will only be two Meter Source points if Direct Outputs have not been
configured for the selected channel.
To set the Metering Source points for more channels at a time, use the Meter/
Generator Settings menu (refer to
If a Direct Output is included in a channel's configuration, it can be fed from
one of three points in the audio path. To set the Direct Output source point,
click on one of the three 'wires' connected to the Dir Box (the current con-
nection will be shown solid, while the two possible connections are displayed
as dotted lines).
The Direct Out will now be fed from the selected point in the signal path.
Available points in the signal path are:
•
After Input Block;
•
Pre Fader & Mute;
•
After Fader & Mute.
The selected Direct Output source points are saved within snapshots and
presets.
Tip
If you have changed the order of the processing blocks, note that the Meter
and Direct Out source points will move together with the processing blocks
to which they are attached (except the Input Block, which cannot be moved).
The Desk Label displays will show Source Labels (from the General Patch)
if the console is set to Inherited Label mode and if a source is patched in to
the channel. If you wish to remain in Inherited Mode, but do not wish to see
Source Labels for certain channels, check the Defeat Source Label Inheritance
box. The Desk Label display will now show the name of the channel rather
than the Source Label, assuming the user label on the Channel Patch has not
been changed from the default. If the user label has been changed on the
Channel Patch screen, the Desk Labels will display this user label when the
Defeat Source Label Inheritance box has been checked. user labels entered
on the Channel Patch screen are saved with snapshots and presets.
SW V5.3
Vista 1 Digital Mixing System
chapter
4.6.1.2.2).
GC Operation 4-33
Advertisement
Chapters
Table of Contents
