Setups; Fx Engine; Meter/Generator - Studer Vista 1 Operating Instructions Manual

4.6.1.2

Setups

4.6.1.2.1

FX Engine

4.6.1.2.2

Meter/Generator

Metering / Meter Position
Metering / Overload LED
Metering / Headroom Threshold
Metering / Meter History
Generator / Level
Generator / Frequency
Document generated: 18.04.17
If there are optional Vista FX units connected to the system, this button allows
to configure the FX structure to be used within the current title. For details
please see chapter 9.
The Meter/Generator Settings page is used for adjusting various settings of
the desk channel strip metering and test generator. Generator defaults are
automatically saved in the
system, so that the last used defaults are available after the next start of your
system.
This action globally sets the metering signal source for all the channels of
the same type to the same point within the signal path. It is usual to set the
Input Channel and Monitor Channel meter sources to Input and those of the
Group, AUX and Master Channels to the Post-Fader position. However,
meter positions may be changed on a channel-by-channel basis and saved
with snapshots and presets.
If 'Shows Entering Headroom' is ticked, the Overload LEDs on the channel
strips as well as the red overload sign on the TFT screens illuminates when
the signal level enters the headroom set with 'Headroom Threshold' instead
of an overload condition.
The desired headroom can be set here; this setting doesn't make any level
changes but just sets the threshold level of the bargraph meters. Default set-
ting: –9 dB , i.e. 9 dB below clipping occurs.
FS
This slider allows setting the speed of the meter history view in four steps
from 0.5 s/div (fastest) to 5 s/div (slowest). Default: 1 s/div.
Sets the test signal generator's level to the desired value. Levels can be set
to off and, in 1 dB steps, from –90 to +10 dB
turned off by moving the Level slider all the way to the left.
Sets the test signal generator's frequency (sine wave only) to the desired value.
The generator frequency can be set in 1/12
SW V5.3
Vista 1 Digital Mixing System
D950system\shutdown.pfc
. The Generator Level can be
FS
octave steps from 19.95 Hz to
th
file when quitting the
GC Operation 4-109