Control Network; Vista 1, 6, 7, 8; Ip Addresses - Studer Vista 1 Operating Instructions Manual

Vista 1 Digital Mixing System
8.5.7

Control Network

IP: 192.168.1.xxx
SUBN: 255.255.255.0
IP: 192.168.1.xxx
SUBN: 255.255.255.0
Only Virtual Vista or Vista CR at a time
Vista Compact Remote
WLAN Port
Port 1:
(Use either Port 1 or WLAN
IP: 192.168.1.xxx
to connect to the Desk)
SUBN: 255.255.255.0
IP: 192.168.1.52
SUBN: 255.255.255.0
STUDER Plugin Engine
IP: 192.168.1.xxx
SUBN: 255.255.255.0
RELINK NETWORK - e.g. OnAir 2500
MAC :
IP: 192.168.1.xxx
SUBN: 255.255.255.0
CONTAINER:
8.5.7.1

Vista 1, 6, 7, 8

8.5.8

IP Addresses

8-18 RELINK
All systems that need to be part of the I/O Sharing network need to be inter-
connected via Ethernet. On the Vista side, it is always the desk that needs to
be networked, as shown the example below.
NETWORK CONFIGURATION RECOMMENDATION - VISTA 1
1 GB Ethernet Switch
(Optional)
HiQnet Device
Virtual Vista
• The Vista desk networked (Ethernet)
• Tie lines between cores are used (MADI, AES, or HD Links)
• DNET technology from the OnAir product range
• The OnAir configuration tool can also be used for setup on the Vista side
Since Vista 1, 6, 7 and 8 are not equipped with a second network port per
default, an external Ethernet switch needs to be used. In the case of a Vista 8
with a redundant control system it is recommended to connect the Ethernet
switch between the network port of the main control system and the bridge
card of the SCoreLive. The network port of the redundant control system
would then still be connected straight to the second port of the bridge card.
See the blockdiagram above.
SW V5.3
LAN 1: 192.168.1.129
SUBN: 255.255.255.0
LAN 1: 192.168.1.128
SUBN: 255.255.255.0
0 18.04.2017/wp 1 12.09.2017/wp
Vista
NETWORK CONFIGURATION RECOMMENDATION - VISTA 1
Optional Meterbridge
VISTA 1
2 3 4
IP Configuration Vista 1.vsd
Document generated: 14.04.17