Table of Contents
Advertisement
Vista 1 Digital Mixing System
2.2.5.3
Control room Monitoring
MONO, L-R, LCRS, 5.1
METER MON
L, C, R, LS, RS, LFE These keys act as solo or mute keys for each speaker being currently active,
SOLO, SOLO IN PLACE
2-26 Desk Operation
Selects the control room monitoring format. The monitoring section hosts a
5.1-to-two-channel downmixer. When L-R is active and the selected monitor-
ing source delivers a 5.1 signal, the six channels get mixed down to two chan-
nels automatically. The way this downmix is done can be set in a dialog box
on the Graphical Controller screen. This screen becomes visible by pressing
the SETUP button.
The MONO setting will sum the left and right monitor speaker signals.
Ø, X
Phase inversion on left channel, and left/right channel swap for mono or two-
channel stereo mode.
INS DEC
Inserts the encoder/decoder chain into the monitoring path. Inputs/Outputs
can be found on the rear of the desk. This function needs to be activated in a
.ini file on the system at installation time. Edits may only be done by educated
Studer service personnel.
Makes the monitor meters indicate the monitor output signal levels instead
of the pre-assigned signals.
depending on the monitoring format selection. Mode is pre-selected by the
SOLO and MUTE keys located above these keys. It is also possible to clear all
pressed keys at once with the circular CLR key next to MUTE.
These keys define the mode the console is in when a cannel strip SOLO key
is pressed. It can be either SOLO (post-fader listening incl. pan), or SOLO IN
PLACE (solo by muting all channels but the selected one, masters and other
defined channels; destructive mode). Pressing SOLO for several seconds
allows adjusting the solo offset level applied in the monitoring whenever a
solo is active. The offset level is then indicated by the 'dB SPL' display that
SW V5.3
Document generated: 18.04.17
Advertisement
Chapters
Table of Contents
