Graphical Controller Basics; Sources And Targets - Studer Vista 1 Operating Instructions Manual

4.3

Graphical Controller Basics

4.3.1

Sources and Targets

Document generated: 18.04.17
This chapter describes the basic concepts of the work with the graphical
controller (GC).
Generally, all audio signals available to the Vista can be divided into Sources
and Targets. These names are used rather than 'Input', 'Out put', etc., in order
to avoid any confusion about where the audio signal comes from and goes to.
Sources: A Source is anything that delivers an audio signal:
• Digital Input Interface (e.g. AES/EBU or MADI);
• Analog Input Interface (e.g. HQ mic/line input);
• Channel Output (for example, direct output of input channel #24, master
output, etc.);
• Channel Insert Send;
• Bus Output (unlike with analog consoles, any bus is a valid audio signal
source within Vista; for example, AUX Mono Bus 12 can be used to feed
an output interface, or to become the source to an input channel);
• Test Generator.
Targets:
A Target is anything that can receive one (mono or stereo) audio signal:
• Channel Input 1 (first audio input to a channel; free for all input channels.
It is used to connect Sources to input/track monitor channels, such as a
MADI output from a digital multi-track to a track monitor channel, or the
corresponding bus to an output channel, such as a Group, Master, or AUX
channel);
• Channel Input 2 (second audio input to a channel; free for all channels);
• Channel Input 3 (third audio input to a channel; used for the test generator
connection per default, can be re-patched to any source at any time),
• Channel insert returns;
• Digital output interfaces (e.g. AES/EBU or MADI);
• Analog output interfaces.
Sources and Targets implicitly behave as mono or stereo, depending on their
character. A stereo Source or Target can be treated, nevertheless, as consis-
ting of two mono parts. Any Source can be connect ed to as many Targets as
needed via the General Patch page. However, a Target (stereo or mono) can
have only one Source (stereo or mono) assigned to its input.
SW V5.3
Vista 1 Digital Mixing System
GC Operation 4-9