Monitoring Source Selection - Studer Vista 1 Operating Instructions Manual

Vista 1 Digital Mixing System
2.2.5.5

Monitoring source selection

2-30 Desk Operation
First select the target to be changed: CR (control room), STUDIO A, or
STUDIO B. Then select the appropriate source key. All keys are fully user-
definable by using the monitoring setup dialog in the Graphical Controller
application (accessible to system administrators only). Each key may inde-
pendently feed a set of one to six loudspeakers. It is therefore possible to
have a two-channel stereo source on one key, while another key selects a 5.1
surround source.
The 16 keys have clip-on caps for inserting individual labels mirroring the
configuration. Shown above is the factory default definition.
For the control room, it is possible to activate the SOURCE SELECTOR top
Note:
row to be 'sub-selectors' rather than selectors, allowing 12 sources to be
assigned to each of these keys. This functionality makes 60 sources avail-
able for listening in the control room, rather than the standard 16. Activation
is done by editing the monitoring.ini file. This usually is done by the system
administrator only.
Pressing one of the 'sub-selectors' will make one of the 12 sub-sources
selected and audible in the monitoring. Pressing the sub-selector again will
open up a list of all 12 sources available for this sub-selector on the Graphi-
cal Controller screen. Select any of the 12 with the touchpad, then close the
dialog by pressing the same sub-selector key again. If none of the 12 sources
is selected, the dialog will pop up automatically upon the first key press in
order to make a selection with the touchpad.
SW V5.3
POPUP POPUP
1 2
AUX AUX
1 2
LINE OFF
5.1 AIR
DESK DESK
ST 5.1
POPUP POPUP
3 4
AUX AUX
3 4
MON MON
1 2
MAIN MAIN
ST 5.1
Document generated: 18.04.17