Custom Panel (Gpio Keys); Jingle Player - Studer Vista 1 Operating Instructions Manual

2.2.5.6

Custom panel (GpIo keys)

2.2.5.7

Jingle player

Document generated: 18.04.17
GP GP
1
GP GP
5
This area contains keys for controlling the general purpose control outputs
(GPO). The control inputs (GPI) can be used for illuminating the keys. The
factory default configuration is GPO 1-12 on the CUSTOM PANEL GPIO socket
on the rear panel, for the pinout refer to
Keys no. 7-12 may also be reconfigured to control desk-internal tasks, such
as cue list functions.
JINGLE JINGLE
1
JINGLE JINGLE
5
The integrated jingle player is a stereo playback-only device intended for up
to eight different audio clips, such as station identifier jingles, applause etc.,
that can be triggered from the eight JINGLES keys shown above.
A jingle immediately starts playing upon pressing one of these keys. While
the clip is playing the key is illuminated. If the key is pressed again while
playing, the clip immediately restarts. If a different jingle key is pressed while
a jingle is playing, playback stops, and the new clip immediately starts.
These clip files come from a USB memory device (e.g. USB stick) that is con-
nected to the USB socket located below the handrest next to the headphones
socket.
The jingle player keys have clip-on caps that allow inserting individual labels,
mirroring either the audio file names or the jingle key numbers.
The Virtual Vista application shows the jingle player buttons in 'Online' mode
only.
For additional Jingle Player information and requirements please refer to
chapter 2.2.9.
SW V5.3
Vista 1 Digital Mixing System
GP
2 3
GP
6 7
chapter 2.1.4.1.1.
JINGLE
2 3
JINGLE
6 7
GP
4
GP
8
JINGLE
4
JINGLE
8
Desk Operation 2-31