Table of Contents
Advertisement
3
VisToniCs PARAmETERs
3.1
introduction
3.2
View Changes
3.2.1
Global View Change
Document generated: 18.04.17
The desk can show different audio controls on the Vistonics™ screens. The
controls differ in type of graphical viewing, shapes, and colors. If required,
they are grouped together with frames in order to give the user maximum
information without the need to read text on the display. The view of the audio
controls can be changed either globally for the whole console, or locally, i.e.
for one single channel.
When pressing one of the keys in the GLOBAL VIEW areas, the default view of
the fader bay is changed. The control bay remains with its own view unless
FOLLOW is active. Each channel strip can show parameters on up to four
rotaries and their associated key. Only one global view key can be active at
a time.
Some views will not cover all four rotaries, depending on the function (e.g.
a 2-channel pan covers only the bottom rotary) or the currently active DSP
configuration (e.g. if only 3 mono AUX busses are configured). After a view
is activated, the corresponding key is lit. When this key is pressed again, all
previous views (i.e., the ones other than the currently pressed global view
key) will be blanked. So the selection of parameters can be done in a quite
flexible way. When pressing AUX MONO 1-4 followed by PAN, the result will
be AUX 1-3 on rotaries 1 through 3, and pan on rotary 4. When pressing PAN
a second time, rotaries 1 through 3 are blank and pan will still be displayed
on rotary 4.
No rule without exceptions:
• Some of the AUX MONO or AUX STEREO keys may be without function;
this depends on the currently loaded configuration.
• When the PRE / POST key in the fader bay's GLOBAL VIEW area is active,
the AUX views change to pre-/post-fader selection.
• As a special global view change, the GLOBAL VIEW: BUS ASN key lets the
EQ, Dynamics, and pan curves on the lower part of the TFT display disap-
pear and shows all bus assignments instead
GLOBAL VIEW: BUS ASN again makes the curves reappear.
SW V5.3
Vista 1 Digital Mixing System
(see chapter
3.3.13). Pressing
Parameters 3-3
Advertisement
Chapters
Table of Contents
