Busyout Packet-Control - Avaya Definity SI Maintenance Manual

Maintenance Commands and Trouble-Clearing Aids
Field descriptions
Port
Maintenance Name
Alt. Name
Result
Error Code

busyout packet-control

This command places the packet-control circuit pack in a maintenance busy state,
and tears down each point-to-point signaling link that terminates on this
packet-control. No periodic or scheduled test is performed on the busied out
packet-control until it is released. A warning alarm (error type 18) is generated on
the busied out packet-control, so that INADS can determine the state of the
object. The release packet-control command reactivates the board and initiates
recovery on all point-to-point signaling links terminated on this packet-control.
Action/
Object Qualifier
busyout location
packet-
control
Feature Interactions
In a duplicated system, the packet-control busyout of standby process
complex is not allowed.
When the packet-control in the active control complex is busied out, all
connectivity across the Packet Bus is severed. Thus, all ISDN-BRI
point-to-point signaling links that have been established through the active
packet-control are torn down by the busyout packet-control command.
The release packet-control command re-establishes all Packet Bus
connectivity.
8-12 Issue 4 May 2002
Port address (cabinet-carrier-slot-circuit)
Name of busied out maintenance object:
Not applicable
Test result: Pass, Abort, Fail
Numeric code explaining why the release failed or aborted.
Refer to the detailed list of codes by test number for each MO.
Qualifier Description
Applies to duplicated
configurations only - a
carrier that contains
packet-control in the
system. Valid locations =
1A or 1B.
Examples
busyout packet-control
1A
busyout packet-control
1B
MODEM-PT
Logins Defaults
init simplex
inads systems
craft (optional) =
cabinet 1,
carrier A
duplex
systems =
cabinet 1,
carrier of
choice.
Feature
Interactions
See below
555-233-123