Track Resolution Ipv6 Route - Dell C9000 Series Reference Manual

If the next-hop address in the ARP cache ages out for a route tracked for its
reachability, an attempt is made to regenerate the ARP cache entry to if the next-hop
address appears before considering the route DOWN.
Related
Commands

track resolution ipv6 route

Configure the protocol-specific resolution value used to scale an IPv6 route metric.
C9000 Series
Syntax
track resolution ipv6 route {isis resolution-value | ospf
resolution-value}
To return to the default setting, use the no track object-id command.
Parameters
object-id
isis resolution-
value
ospf resolution-
value
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
8.3.12.0
8.4.1.0
• show track ipv6 route
configuration, current state, and clients which track the route.
• track ipv6 route reachability
IPv4 route.
Enter the ID number of the tracked object. The range is from 1
to 500.
Enter the resolution used to convert the metric in the routing
table for ISIS routes to a scaled metric.
Enter the resolution used to convert the metric in the routing
table for OSPF routes to a scaled metric.
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Introduced on the S6000-ON.
Introduced on the S4810.
Introduced.
– displays information about tracked IPv6 routes, including
– configures object tracking on the reachability of an
Object Tracking 1479