Show Config (From Interface Range Mode) - Dell C9000 Series Reference Manual

show config (from INTERFACE RANGE mode)

Display the bulk configured interfaces (interface range).
C9000 Series
Syntax
show config
Command Modes INTERFACE RANGE (conf-if-range)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Example
Dell(conf)# interface range tengigabitethernet 1/1 - 2
Dell(conf-if-range-te-1/1-2)# show config
!
interface TenGigabitEthernet 1/1
!
interface TenGigabitEthernet 1/2
Dell(conf-if-range-te-1/1-2)#
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
no ip address
switchport
no shutdown
no ip address
switchport
no shutdown
Interfaces 956