Cam-Acl-Egress - Dell C9000 Series Reference Manual

The total amount of space allowed is 16 FP Blocks. System flow requires four blocks
and these blocks cannot be reallocated. The total number of blocks must be equal to
12. The ipv4acl profile range is from 0 to 8.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 12.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which is
from 0 to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
If you enabled BMP 3.0, to perform a reload on the chassis to upgrade any
configuration changes that have changed the NVRAM content, use the reload
conditional nvram-cfg-change command.
You can use the cam-acl default command in Configuration Terminal Batch mode
to reset ACL CAM entries to default settings in a dual-homing setup.

cam-acl-egress

Allocate space for IPv6 egress ACLs.
C9000 Series
Syntax
cam-acl-egress {default | l2acl 1-3 ipv4acl 1-3 ipv6acl 0-2}
Parameters
default
l2acl 1-3 ipv4acl
1- 3 ipv6acl 0-2
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Use the default CAM profile settings, and set the CAM as follows:
• L2 ACL(l2acl): 1
• L3 ACL (ipv4acl: 1
• IPv6 L3 ACL (ipv6acl): 2
Allocate space to support IPv6 ACLs. Enter all of the profiles and
a range. Enter the CAM profile name then the allocation amount.
The ipv6acl range must be a factor of 2.
IPv6 Access Control Lists (IPv6 ACLs) 1242