Related
clns host
Commands
ignore-lsp-errors
Ignore LSPs with bad checksums instead of purging those LSPs.
C9000 Series
Syntax
ignore-lsp-errors
To return to the default values, use the no ignore-lsp-errors command.
Defaults
In IS-IS, the default deletes LSPs with internal checksum errors (no ignore-lsp-
errors).
Command Modes
ROUTER ISIS
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.11.1
Usage Information IS-IS normally purges LSPs with an incorrect data link checksum causing the LSP
source to regenerate the message. A cycle of purging and regenerating LSPs can occur
when a network link continues to deliver accurate LSPs even though there is a link
causing data corruption. This process could cause disruption to your system operation.
— defines a name-to-NSAP mapping.
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Intermediate System to Intermediate System (IS-IS)
1072