Iscsi Target Port - Dell C9000 Series Reference Manual

The following is the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.6.(0.0)

iscsi target port

Configure the iSCSI target ports and optionally, the IP addresses on which iSCSI communication is monitored.
C9000 Series
Syntax
iscsi target port [tcp-port-2...tcp-port-16]ip-address [ip-
address]
To remove the configured iSCSI target ports or IP addresses, use the no iscsi
target port command.
Parameters
tcp-
port-2...tcpport-
16
ip-address
(Optional)
Defaults 860, 3260
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.6(0.0)
Usage Information You can configure up to 16 target TCP ports on the switch in one command or multiple
commands.
Description
Introduced on the C9010.
Introduced on the Z9500.
Enter the tcp-port number of the iSCSI target ports. The tcp-
port-n is the TCP port number or a list of TCP port numbers on
which the iSCSI target listens to requests. Separate port numbers
with a comma. The default is 860, 3260.
Enter the ip-address that the iSCSI monitors. The ip-address
specifies the IP address of the iSCSI target.
Description
Introduced on the C9010.
Introduced on the Z9500.
iSCSI Optimization 1303