Disable - Dell C9000 Series Reference Manual

Defaults none
Command Modes SPANNING TREE PVST+ (The prompt is "config-pvst".)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.1
Related
protocol spanning-tree pvst
Commands

disable

Disable PVST+ globally.
C9000 Series
Syntax
disable
To enable PVST+, use the no disable command.
Defaults Disabled.
Command Modes CONFIGURATION (conf-pvst)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced.
— enter SPANNING TREE mode on the switch.
Description
Introduced on the C9010.
Introduced on the Z9500.
Per-VLAN Spanning Tree Plus (PVST+) 1640