Advertise Med Power-Via-Mdi - Dell C9000 Series Reference Manual

Parameters
power-via-mdi
Defaults Disabled
Command Modes
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
Usage Information The advertise dot3–tlv power—via—mdi command enables the system to
advertise IEEE 802.3at power-via-mdi TLV to advertise its power negotiation
capabilities with the powered devices via Link Layer Discovery Protocol (LLDP). You can
configure this command either on a specific interface or globally.
Example
Dell(conf)#interface peGigE 0/0/0
Dell(conf-if-pegi-0/0/0)#protocol lldp
Dell(conf-if-pegi-0/0/0-lldp)#advertise dot3-tlv power-via-mdi
Dell(conf-if-pegi-0/0/0-lldp)#

advertise med power-via-mdi

Configure the system to advertise IEEE 802.1ab extended power-via— MDI TLV.
C9000 Series
Syntax
[no] advertise med power-via-mdi
To return to the default, use the no advertise med power-via-mdi command.
Parameters
power-via-mdi
Defaults Disabled
Command Modes
Enter the keyword power—via-mdi to advertise IEEE 802.3at
power-via-mdi TLV.
• LLDP CONFIGURATION (conf-lldp)
• INTERFACE LLDP CONFIGURATION (conf-if-interface-lldp)
Description
Introduced on the C9010.
Enter the keyword power—via-mdi to advertise IEEE 802.1ab
MED Extended power-via-mdi TLV.
• LLDP CONFIGURATION (conf-lldp)
• INTERFACE LLDP CONFIGURATION (conf-if-interface-lldp)
Port Extenders (PE) 1749