Ip Igmp Querier-Timeout - Dell C9000 Series Reference Manual

Version
7.8.1.0
7.7.1.0
E-Series legacy
command

ip igmp querier-timeout

Change the interval that must pass before a multicast router decides that there is no longer another multicast
router that should be the querier.
C9000 Series
Syntax
ip igmp querier-timeout seconds
To return to the default value, use the no ip igmp querier-timeout command.
Parameters
seconds
Defaults 125 seconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.5(0.1)
9.2(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Description
Introduced on the S-Series.
Introduced on the C-Series.
Enter the number of seconds the router must wait to become
the new querier. The range is from 60 to 300. The default is 125
seconds.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Internet Group Management Protocol (IGMP) 1131