Default-Vlan Disable - Dell C9000 Series Reference Manual

Usage Information To return VLAN 1 as the Default VLAN, use this command syntax (default-vlan-id
1).
The Default VLAN contains only untagged interfaces.
Use this command in Configuration Terminal Batch mode to specify a default VLAN in a
dual-homing setup.
Related interface vlan
Commands

default-vlan disable

Disable the default VLAN so that all switchports are placed in the Null VLAN until they are explicitly configured
as a member of another VLAN.
C9000 Series
Defaults Enabled
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.3.1.0
Usage Information The no default vlan disable command is not listed in the running-configuration,
but when the default VLAN is disabled, default-vlan disable is listed in the
running-configuration. Use this command in Configuration Terminal Batch mode to
disable the default VLAN in a dual-homing setup.
— configures a VLAN.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced
Layer 2 1329