Default Interface - Dell C9000 Series Reference Manual

Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
7.4.1.0
Usage Information Important Points to Remember:
Related show interfaces
Commands

default interface

Resets a physical interface to its factory-default settings.
C9000 Series
Syntax
default interface interface slot/port-range
Parameters
interface slot/
port-range
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Modified for E-Series: Revised from 78 to 240 characters.
• To use special characters as a part of the description string, you must enclose the
whole string in double quotes.
• Spaces between characters are not preserved after entering this command unless
you enclose the entire description in quotation marks ("desc_text").
• Entering a text string after the description command overwrites any previous
text string that you previously configured as the description.
• The shutdown and description commands are the only commands that you
can configure on an interface that is a member of a port-channel.
• Use the show interfaces description command to display descriptions
configured for each interface.
— displays information about an interface.
Enter one of the following interface types and port information
to specify a single port or a range of ports. To specify a port
range, you can enter a hyphenated range and/or individual port
numbers separated with commas; for example, default
interface tengigabitethernet 1/0-4,7,9-11. To enter
any random number of ports, you can enter a comma-separated
Interfaces 926