Mac-Address-Table Station-Move Refresh-Arp - Dell C9000 Series Reference Manual

mac-address-table station-move refresh-arp

Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs due
to a topology change.
C9000 Series
Syntax
[no] mac-address-table station-move refresh-arp
Defaults Enabled.
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0
7.6.1.0
7.4.1.0
Usage Information For details about using this command, see the "NIC Teaming" section of the Layer 2
chapter in the Dell Networking OS Configuration Guide.
To disable the ARP refresh feature, use the no mac-address-table station-move
refresh-arp command.
Use this command in Configuration Terminal Batch mode to refresh the egress
interface in a dual-homing setup.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Layer 2 1313