hello-time
seconds
Defaults
2 seconds
Command Modes
CONFIGURATION (conf-pvst)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.2.1.1
Related
Commands
vlan max-age
To maintain configuration information before refreshing that information, set the time interval for the PVST+
bridge.
C9000 Series
Syntax
vlan vlan-range max-age seconds
To return to the default, use the no vlan max-age command.
Enter the keywords hello-time then the time interval, in
seconds, between transmission of BPDUs. The range is from 1 to
10 seconds. The default is 2 seconds.
Description
Introduced on the C9010.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
•
vlan bridge-priority
•
vlan forward-delay
— changes the time interval before Dell Networking OS
transitions to the forwarding state.
•
vlan max-age
— changes the time interval before PVST+ refreshes.
•
show spanning-tree pvst
— sets the bridge-priority value.
— displays the PVST+ configuration.
Per-VLAN Spanning Tree Plus (PVST+)
1654