Diag - Dell C9000 Series Reference Manual

• show os-version
• show privilege
• show redundancy
• show revision
• show system
• show tech-support
• show version
• telnet-peer-stack-unit
For information about the commands you can enter from a C9010 console to configure a port extender, see
Port Extenders (PE) chapter.
Topics:
•

diag

• offline
• online
• power-cycle
• show control-bridge status
• show system
• telnet-peer-stack-unit
• upgrade system
diag
Run offline diagnostics on all stack-units.
C9000 Series
Syntax
diag {stack-unit unit-number} [alllevels | level0 | level1 |
level2] [interactive] [testname name] [terminate]
Parameters
stack-unit unit-
number
alllevels
level0
Enter the stack-unit value to run offline diagnostic test on a
specified stack-unit. The stack-unit range is 0 to 7.
Enter the keyword all levels to run the complete set of
offline diagnostic tests.
Enter the keyword level0 to run Level 0 diagnostics. Level 0
diagnostics check for the presence of various components and
perform essential path verifications. In addition, they verify the
identification registers of the components on the board.
PE Console Commands 1612