Ipv6 Route - Dell C9000 Series Reference Manual

Command Modes
INTERFACE
INTERFACE (BATCH MODE)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.3.2.0
Usage Information By default, all prefixes configured as addresses on the interface are advertised. This
command allows control over the individual parameters per prefix; you can use the
default keyword to use the default parameters for all prefixes. If a prefix has been
configured with lifetime parameter values, the default values cannot be applied using
the ipv6 nd prefix default no-autoconfig command. Use this command in
the Configuration Terminal Batch mode to advertise in a dual-homing setup.

ipv6 route

Establish a static IPv6 route.
C9000 Series
Syntax
ipv6 route ipv6-address prefix-length {ipv6-address | interface |
interface ipv6-address} [distance] [tag value] [permanent][weight
weight-value [vrf vrf-name]
To remove the IPv6 route, use the no ipv6 route ipv6-address prefix-length
{ipv6-address | interface | interface ipv6-address} [distance]
to 4294967295. The default is 604800. The maximum value
means that the preferred lifetime and does not expire.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series TeraScale, C-Series, and S-Series.
IPv6 Basics 1280