Ip Igmp Query-Max-Resp-Time - Dell C9000 Series Reference Manual

Version
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
7.6.1.0
7.5.1.0
E-Series legacy
command.
Usage Information If you have configured the hello interval value to be greater than 18000, you must first
reset that value to be less than or equal to 18000 before upload. Otherwise, the
command execution fails during bootup and the hello interval value is set to the default
value.

ip igmp query-max-resp-time

Set the maximum query response time advertised in general queries.
C9000 Series
Syntax
ip igmp query-max-resp-time seconds
To return to the default values, use the no ip igmp query-max-resp-time
command.
Parameters
seconds
Defaults 10 seconds
Command Modes
INTERFACE
INTERFACE (BATCH Mode)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Description
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the S-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
Introduced on the C-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
Enter the number of seconds for the maximum response time.
The range is from 1 to 25. The default is 10 seconds.
Internet Group Management Protocol (IGMP) 1133