Crypto Ipsec Policy - Dell C9000 Series Reference Manual

Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
9.2(0.0)
Usage Information
Example
Dell(conf)#int ten 0/4
Dell(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64
Dell(conf)#int ten 0/6
Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64

crypto ipsec policy

Create a crypto policy used by ipsec.
C9000 Series
Syntax
crypto ipsec policy name seq-num ipsec-manual
To delete a crypto policy entry, use the no crypto ipsec policy name seq-num
ipsec-manual command.
Parameters
name
seq-num
Defaults none
Command Modes CONFIGURATION
•
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the Z9000, S4810, and S4820T.
• Both sides of the link must specify the same transform set.
• You can create up to 64 transform sets.
Enter the name for the crypto policy set.
Enter the sequence number assigned to the crypto policy entry.
null — Causes an encryption policy configured for the area
to not be inherited on the interface.
Internet Protocol Security (IPSec) 1157