Show Port-Channel-Flow - Dell C9000 Series Reference Manual

Example (port-
Dell#show interfaces port-channel 1-2 brief
range)
Codes: L - LACP Port-channel
Related
show lacp
Commands

show port-channel-flow

Display an egress port in a given port-channel flow.
C9000 Series
Syntax
show port-channel-flow outgoing-port-channel number incoming-
interface interface {source-ip address destination-ip address} |
{source-port number destination-port number} | {src-mac address
dest-mac address {vlan vlanid | ether-type}}
Parameters
outgoing-port-
channel number
incoming-
interface interface
source-ip address
destination-ip
address
O - OpenFlow Controller Port-channel
A - Auto Port-channel
I - Internally Lagged
LAG Mode Status
1 L3 down
— displays the LACP matrix.
Enter the keywords outgoing-port-channel then the
number of the port channel to display flow information.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
Enter the keywords incoming-interface then the interface
type and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
gigabitethernet then the slot/port information.
• For a port extender (PE) Gigabit Ethernet interface, enter
the keyword peGigE then the peid/stack-unit/port-pipe id
information.
NOTE:
extended bridge feature is enabled.
Enter the keywords source-ip then the IP source address in IP
address format.
Enter the keywords destination-ip then the IP destination
address in IP address format.
Uptime Ports
00:00:00 Te 11/1
The peGigE option is available only when the
(Down)
Interfaces 1029