Configure Global Cos Settings; Configure Cos Interface Settings For An Interface - NETGEAR ProSafe XS728T User Manual

ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual

Configure Global CoS Settings


To configure CoS trust mode settings on all interfaces:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Switch on page 10.
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select QoS> CoS > Basic > CoS Configuration.
The CoS Configuration page displays.
6. From the Global Trust Mode menu, select one of the following trust mode options for
ingress traffic on the switch:
• Untrusted. Do not trust any CoS packet marking at ingress.
• 802.1p. The eight priority tags that are specified in IEEE 802.1p are p0 to p7. This
QoS setting lets you map traffic with one of eight priority levels to one of eight internal
hardware priority queues. The default mode is 802.1p.
• DSCP. The six most significant bits of the DiffServ field are called the Differentiated
Services Code Point (DSCP) bits. This QoS setting lets you map traffic with particular
DSCP bits to one of multiple queues.
7. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.

Configure CoS Interface Settings for an Interface

Use the CoS Interface Configuration page to configure the interface shaping rate and
interface ingress rate limit to one or more interfaces.

To configure CoS settings for an interface:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
Configure Quality of Service
199
Change the Default IP Address of the