Product Features - Comtech EF Data SLM-5650A Installation And Operation Manual

1.3

Product Features

The SLM-5650A incorporates the following features:
•
MIL-STD-188-165A compliance (Types A, B, D, E, F)
•
Intelsat IESS-308, -309, -310, and -315
•
A rugged, one-rack unit (1RU) enclosure
•
Low weight and low power dissipation
•
Selectable 70/140 MHz or L-Band (950 to 2000 MHz) IF interfaces
•
EIA-530/422 Data Interface (built-in, to 20 Mbps)
•
EIA-613/HSSI Data Interface (built-in, to 51.84 Mbps)
•
EIA-485/EIA-232 Interface for serial remote control
•
Ethernet Interface for remote control using Telnet, SNMP, HTTP, HTTPS, and SSH
•
Plug-in Data Interface supporting the optional Gigabit Ethernet, Network Processor (NP),
G.703, and Low Voltage Differential Signaling (LVDS) interface modules
•
Asymmetrical Loop Timing
•
Data Source Bit Synchronization (Clock recovery for input data without an associated
transmit clock)
•
Full-featured, built-in BER test-set
•
Electrical and Ethernet Rx constellation monitor
•
Adaptive Equalizer for high order modulation types
•
64 kbps to 155.52 Mbps (Modulation-, code rate-, and interface-dependent)
•
BPSK, QPSK, OQPSK, 8PSK, 8QAM, and 16QAM
•
FEC Rates: 5/16, 1/2, 2/3, 3/4, 5/6, 7/8, 21/44, 5/16, 17/18, .378, .451, .541, and 1/1
•
Viterbi and Reed-Solomon Codec
•
Turbo Product Codec (Optional)
•
Low-Density Parity Check (LDPC) coding in three block sizes: ULL, LL, and HP (optional)
•
Direct Sequence Spread Spectrum (DSSS) (optional with LDPC)
•
Sequential FEC (optional)
•
Static Bridge, Router, and Bridge Point-to-Multipoint (BPM) Modes (via the optional NP
Interface)
•
TRANSEC Encryption (optional)
•
Firmware updating capability
Introduction 1–3
SLM-5650A Satellite Modem
Revision 10
MN-SLM-5650A