Comtech EF Data SLM-5650A Installation And Operation Manual page 257

10.3.11 TRANSEC Module Interface Commands and Queries
The instruction codes that follow are valid only when the optional TRANSEC Module is installed in the SLM-5650A Satellite Modem.
Controller-to-Target
Instruction Code and
Qualifier
Parameter
Type
Command Query
TRANSEC SMG= SMG?
Ethernet
Interface
Gateway IP
Address
TRANSEC SMI= SMI?
Ethernet
Interface
Management IP
Address and
Subnet Mask
Serial Remote Control
Arguments
for Command
(Note that all arguments are ASCII numeric codes from 48 to 57)
or Query
15 bytes Command or Query.
Set or return the Gateway IP Address for the TRANSEC Module in
the form aaa.bbb.ccc.ddd, where:
aaa.bbb.ccc.ddd = Gateway IP Address
Example: <0001/SMG=010.006.030.001{CR}
18 bytes Command or Query.
Sets or returns the Management IP Address and Subnet Mask for the
TRANSEC Module in the form aaa.bbb.ccc.ddd.ee, where:
aaa.bbb.ccc.ddd = Management IP Address, and
ee = Subnet Mask (0-31)
Example: <0001/SMI=010.006.030.001.24{CR}
Description of Arguments
10–63
SLM-5650A Satellite Modem
Revision 10
Target-to-Controller
Response to Query
Response to
(see Description of
Command
Arguments)
N/A SMG=aaa.bbb.ccc.dd
d
N/A SMI=aaa.bbb.ccc.ddd.
ee
MN-SLM-5650A