Comtech EF Data SLM-5650A Installation And Operation Manual page 348

Upgrade
Chapter 5. FIRMWARE UPDATE
See Chapter 5. FIRMWARE UPDATE for complete details on using the NP HTTP/HTTPS Interface
for upgrading the Base Modem, NP Interface and TRANSEC Module firmware.
Item
Current Running
Upgrade To
Upgrade Image File
E.7.5.2.6 Admin | Defaults
This Reset selection only resets the NP Card. The Base Modem and
TRANSEC (if installed) are not reset using this Reset selection.
Use this page to restore all previously-configured NP card parameters – with the exception of the
Admin User Name and the Admin Password (see Section E.3.5.2.3) – to their Factory Default
Configuration settings.
Figure E-12. Admin | Defaults (Factory Default Configurations) Page
Click [Restore Now] to begin the restoration process. At the user prompt (shown at right), click
[OK] to execute the process, or [Cancel] to abort the command.
Appendix E
(read only) – displays current NP Interface Firmware Image as defined on the
Admin | Reboot page (e.g., Image1 or Image2).
(read only) – displays the NP Interface Firmware Image that will be overwritten with
the new image as defined on the Admin | Reboot page (e.g., Image1 or Image2).
Click [Browse] to locate the bulk image on the local computer's file system. Click
[Upload] to upload the image.
E–26
SLM-5650A Satellite Modem
Description
Revision 10
MN-SLM-5650A