Comtech EF Data SLM-5650A Installation And Operation Manual page 102

Hide thumbs Also See for SLM-5650A:

Table of Contents

Refresh the Admin | Upgrade page and verify that the newly-uploaded firmware is reported in the

proper Security Module Bulk Info slot. If not, update the Active Boot Slot Configuration – use the

drop-down menu to select Newest. (This forces the TRANSEC Module to boot using the firmware

with the most recent build date.) Click [Submit] when done.

Firmware Update

Any power failure during this process will result in failure of the

TRANSEC Module.

In the event that an error occurs during the Firmware Application Process, the following

message is displayed:

For troubleshooting purposes, three common reasons for disruption of the Firmware

Application Process are:

Power Failure;

Loss of Ethernet signal (e.g., disconnection of Ethernet cable);

Attempting to load firmware other than the TRANSEC Module bulk firmware

(i.e., FW-0000058x.bin).

Upon successful completion of transfer, the progress bar reads 100%, and the Image

Upgrade Complete message displays:

SLM-5650A Satellite Modem

MN-SLM-5650A

Chapters

Table of Contents