Comtech EF Data SLM-5650A Installation And Operation Manual page 209

Controller-to-Target
Instruction Code and
Qualifier
Parameter
Type
Command Query
Tx Clock Source TCK= TCK?
Tx Reed- TCW= TCW?
Solomon Code
Word
Tx Differential TDE= TDE?
Encoding
Serial Remote Control
Arguments
for Command
(Note that all arguments are ASCII numeric codes from 48 to 57)
or Query
1 byte Command or Query.
Sets or returns the Tx Clock Source in the form x, where:
0 = SCT
1 = Tx Terrestrial
Example: <0001/TCK=1{CR} (selects Tx Terrestrial Clock Source)
1 byte Command or Query.
Sets or returns the Tx RS encoding in the form x, where:
0 = RS(225,205,10)
1 = RS(219,201,9)
2 = RS(208,192,8)
3 = RS(194,178,8)
4 = RS(126,112,7)
5 = RS(220,200,10)
Note: Depending on the active modem mode, overhead type, and
data rate, not all selections will be valid.
Example: <0001/TCW=0{CR} (This is a 'don't care' if RS is Off
under TRS)
1 byte Command or Query.
Sets or returns the Tx Differential Encoding in the form x, where:
x=Tx Differential Encoding:
0=Off
1=On
Note: Depending on FEC type or Modulation Type, not all selections
will be valid.
Example: <0001/TDE=1{CR} (selects Tx Differential Encoding On)
Description of Arguments
10–15
SLM-5650A Satellite Modem
Revision 10
Target-to-Controller
Response to Query
Response to
(see Description of
Command
Arguments)
TCK= TCK=x
TCK?
TCK*
TCK#
TCW= TCW=x
TCW?
TCW*
TCW#
TDE= TDE=x
TDE?
TDE*
TDE#
MN-SLM-5650A