Comtech EF Data SLM-5650A Installation And Operation Manual page 435

Network Parameters
Item
Secure Management IP
Subnet Bits
Gateway IP
Click Update Settings to apply changes made to any of these parameters.
Crypto Officer Credentials
This section is used to create a TRANSEC Module Crypto Officer Username and Crypto
Officer Password. Note that are each restricted to a minimum of 7 and a maximum of 25
characters, excluding: (ASCII Code 58), < (ASCII Code 60), > (ASCII Code 62), " (ASCII Code
34), and ~ (ASCII Code 126).
The default for both the Crypto Officer Username and Password is transec.
Item
Crypto Officer
Username
Password
Confirm Password
Once the Username is entered and the Password is confirmed, click Update Credentials to
finalize this update.
Key Generation
This section is only available for TRANSEC firmware version 2.2.4 or later. Prior firmware
versions will only operate in the Legacy mode.
Item
Key Generation Mode
Appendix F
Allows users to change the IP address of the TRANSEC Module to suit their own
operational environment.
NOTE: If this text box changes, it will be necessary to repeat the process in Section F.4
using the newly-designated IP address, to regain access to the TRANSEC Web
Interface.
Allows users to modify the IP subnet mask of the TRANSEC Module to suit their own
operational environment.
Allows users to modify the default gateway of the TRANSEC Module to suit their own
operational environment.
NOTE: The IP address entered in the text box must match the subnet of the Secure
Management IP. If it does not then the Gateway IP text box will default to 0.0.0.0.
Use this text box to create the desired username.
Use this text box to create the desired password for the username being created.
Use this text box to re-enter the previously entered password.
Allows the user to select the Legacy mode, which is compatible with firmware versions
prior to 2.2.4, or the FIPS approved mode.
F–11
SLM-5650A Satellite Modem
Description
Description
Description
Revision 10
MN-SLM-5650A