Comtech EF Data SLM-5650A Installation And Operation Manual page 504

H.3.2 BPM Mode Configuration
Chapter 1. INTRODUCTION
Chapter 6. FAST ACTIVATION PROCEDURE
Capter 7. FRONT PANEL OPERATION
Appendix D. OPTIONAL NETWORK PROCESSOR (NP) INTERFACE MODULE
For more information about FAST, see:
•
Chapter 1. INTRODUCTION, Section 1.3.1.7 Fully Accessible System Topology (FAST).
•
Chapter 7. FRONT PANEL OPERATION, Section 7.2.7.10 (UTIL:) FAST, and Section
7.3.3.9 CONFIG: Remote
•
Appendix D. OPTIONAL NETWORK PROCESSOR (NP) INTERFACE MODULE,
Section D.2.5.2.1 Admin | Vipersat Mode (FAST Option), and Section D.2.5.2.2 Admin |
FAST Features
BPM Mode is available on the NP Interface as a FAST Option. Once the FAST Access Code has
been purchased during normal business hours from Comtech EF Data Product Support, it is then
activated in the NP Interface-equipped modem via the modem front panel. Once activated, BPM
Mode must then be enabled for operation.
You may enable BPM Mode operation either from the SLM-5650A front panel menu (CONFIG:
Remote  EthernetConfig  Option Card Addr  Network Proc), or from the NP
HTTP/HTTPS Interface 'Admin | Vipersat Modes' page.
Appendix I H–12
SLM-5650A Satellite Modem
Revision 10
MN-SLM-5650A