Comtech EF Data SLM-5650A Installation And Operation Manual page 241

10.3.6 Bulk Configuration Commands and Queries
Controller-to-Target
Instruction Code and
Qualifier
Parameter
Type
Command Query
Configuration CLD= N/A
Load
Configuration CST= N/A
Save
Global MGC= MGC?
Configuration
Serial Remote Control
Arguments
for Command
(Note that all arguments are ASCII numeric codes from 48 to 57)
or Query
1 byte Command only.
Causes the modem to retrieve a previously stored configuration from
Configuration Memory location defined by the one-byte argument (0
to 9).
COMMAND EXAMPLE: <0001/CLD=4{CR} (retrieve modem
configuration from location 4)
1 byte Command only.
Command causes the modem to store the current configuration in
Configuration Memory location defined by the one-byte argument (0
to 9).
COMMAND EXAMPLE: <0001/CST=4{CR} (store the current
configuration in location 4)
Command can Command or Query.
be 177 bytes
Global Configuration of SLM-5650A, in the form:
or 217 bytes;
abcdeeeeeefghijabbbbbbklmnoooooo.ooopppp.ppppqcrestuvwxyyy.y
Query
zABCDEFGHHff.fffIJKLLLLLL.LLLMMMM.MMMMNgggPQRSTUVWX
Response is
YZZZZ.ZZZAAABCDDDDDDDDEE.EFGHIJKLMNNN.NOOO.OPPP.
always 217
PQQ.QR.RSTUVWXXYZZhhhijjjkkkkkmmmmmlllllllllllllllllllllll where:
bytes
a = Modem Operating Mode ....................................... same as MOM
b = Modem RF Band .....................................................same as RFB
c = Modem Interface Type ............................................ same as ITF
d = Modem Reference Clock .......................................same as MRC
eeeeee = Modem Alarm Mask ..................................... same as MSK
f = Carrier Only Test Modes ....................................... same as COM
g = Loopback Test Modes .............................................same as LOP
h = Tx BERT State ......................................................... same as BTX
i = Rx BERT State ....................................................... same as BRX
j = BERT Pattern ........................................................... same as PAT
Description of Arguments
10–47
SLM-5650A Satellite Modem
Revision 10
Target-to-Controller
Response to Query
Response to
(see Description of
Command
Arguments)
CLD= N/A
CLD?
CLD*
CLD#
CST= N/A
CST?
CST*
CST#
MGC= MGC=abcdeeeeeefghi
jabbbbbbklmnoooooo.
MGC?
ooopppp.ppppqcrestu
MGC*
vwxyyy.yzABCDEFGH
MGC#
Hff.fffIJKLLLLLL.LLLM
MMM.MMMMNgggPQ
RSTUVWXYZZZZ.ZZ
ZAAABCDDDDDDDD
EE.EFGHIJKLMNNN.
NOOO.OPPP.PQQ.Q
R.RSTUVWXXYZZhh
hijjjkkkkkmmmmmllllllll
lllllllllllllll
MN-SLM-5650A