Comtech EF Data SLM-5650A Installation And Operation Manual page 249

Controller-to-Target
Instruction Code and
Qualifier
Parameter
Type
Command Query
Clear All AUPC CAA= N/A
Log Entries
Initialize AUPC IAP= N/A
Log Pointer
AUPC Local LCL= LCL?
Carrier Loss
Action
AUPC Local LPC= LPC?
Enable
Number of N/A NUA?
Unread AUPC
Log Entries
Serial Remote Control
Arguments
for Command
(Note that all arguments are ASCII numeric codes from 48 to 57)
or Query
None Command only.
Forces the firmware to clear the firmware AUPC log.
Note: This command takes no arguments.
None Command only.
Resets internal pointer to allow RNA? queries to start at the beginning
of the stored statistics log.
Note: This command takes no arguments.
1 byte Command or Query.
Sets or returns Tx Output Power level setting when local carrier is lost
in the form x, where:
0 = Hold current output power level
1 = Goto Nominal output power level
2 = Goto Maximum output power level
Example: <0001/LCL=0{CR}
1 byte Command or Query.
Sets or returns Local AUPC Control in the form x, where:
0 = Off
1 = On
Note: When Local AUPC Control is enabled, modulator output power
is automatically controlled by the modem. Power output commands
via TPL are not allowed during this mode; although, queries will
function as normal.
Example: <0001/LPC=1{CR} (Turns on Local AUPC Control)
3 bytes Query only.
Returns the Number of AUPC Log Entries that remain Unread over
the serial remote interface, in the form xxx.
Example: >0001/NUS=126{CR}{LF}
Description of Arguments
10–55
SLM-5650A Satellite Modem
Revision 10
Target-to-Controller
Response to Query
Response to
(see Description of
Command
Arguments)
CAA= N/A
CAA?
CAA*
CAA#
IAP= N/A
IAP#
LCL= LCL=x
LCL?
LCL*
LCL#
LPC= LPC=x
LPC?
LPC*
LPC#
N/A NUA=xxx
MN-SLM-5650A