Comtech EF Data SLM-5650A Installation And Operation Manual page 251

Controller-to-Target
Instruction Code and
Qualifier
Parameter
Type
Command Query
Remote Modem RPC= RPC?
AUPC Enable
Remote Modem N/A RPE?
BERT BER
Remote Modem RPL= RPL?
I/O Loopback
Serial Remote Control
Arguments
for Command
(Note that all arguments are ASCII numeric codes from 48 to 57)
or Query
1 byte Command or Query.
Sets or returns Remote Modem AUPC Control in the form x, where:
0 = Off
1 = On
Example: <0001/RPC=1{CR} (Turns on remote modem AUPC
Control)
6 bytes Query only.
Returns the value of the remote modem's BERT BER in the form
a.bEcc where:
a.b = BER value
Ecc = Exponent
Note: Returns 0.0E00 if the BERT is not synchronized to a pattern.
Example: <0001/RPE=4.0E06{CR} (Reports BER as 4.0 x 10
1 byte Command or Query.
Sets or returns Remote Modem I/O Loopback Mode in the form x,
where:
0 = Off
1 = On
Example: <0001/RPL=1{CR} (Turns on remote modem AUPC
Control)
Description of Arguments
10–57
SLM-5650A Satellite Modem
Target-to-Controller
Response to Query
Response to
(see Description of
Command
Arguments)
RPC= RPC=x
RPC?
RPC*
RPC#
N/A RPE=a.bEcc
)
-6
RPL= RPL=x
RPL?
RPL*
RPL#
MN-SLM-5650A
Revision 10