Comtech EF Data SLM-5650A Installation And Operation Manual page 342

E.7.5.2.2 Admin | FAST Features
Chapter 6. FAST ACTIVATION PROCEDURE
Chapter 7. FRONT PANEL OPERATION
This section describes the NP HTTP/HTTPS Interface with Vipersat, Quality of Service (QoS), and
Management Security installed on the SLM-5650A. See Chapter 6. FAST ACTIVATION
PROCEDURE and Chapter 7. FRONT PANEL OPERATION for detailed information on managing
FAST Options.
If the SLM-5650A does not have these QoS or Vipersat FAST options installed, the
QoS and QoS Stats hyperlinks located under the WAN navigation tab, and the
hyperlinks located under the Vipersat navigation tab will not be visible/available to
the user.
If the SLM-5650A does not have the Management Security FAST option installed,
the "IP Interface Security Mode" and "SSH" sections on the 'Admin | Security'
page and the "SNMP v3" section on the 'Admin | SNMP' page will not be visible.
Upgrading the FAST features requires a modem reboot in order for FAST features
to be activated, and may require reconfiguration of all modem parameters.
This read-only page displays available FAST Features as "Installed" or "Not Installed".
Network Processor and Modem FAST Features
Comtech EF Data offers Vipersat, Management Security, NP BPM, Quality of Service (QoS), NP
OW Serial Commands, and NP Antenna Handover functionality as optional FAST Features for the
NP Interface. The modem's Demodulator Only FAST feature status is also provided. To install
these options, you must contact Comtech EF Data Product Support to purchase a modem FAST
Access Code.
Once the 20-digit modem FAST Access Code is obtained, the purchased FAST Feature(s) is
installed via the SLM-5650A front panel (Utility: FAST  Configuration  Enter modem code).
Appendix E
Figure E-8. Admin | FAST Features Page
E–20
SLM-5650A Satellite Modem
Revision 10
MN-SLM-5650A