Comtech EF Data SLM-5650A Installation And Operation Manual page 227

Controller-to-Target
Instruction Code and
Qualifier
Parameter
Type
Command Query
Clear All Stored CAS= N/A
Statistics
CnC Frequency CCF= CCF?
Offset Range
CnC Delay N/A CDM?
Monitor
CnC Frequency N/A CFM?
Offset Monitor
Serial Remote Control
Arguments
for Command
(Note that all arguments are ASCII numeric codes from 48 to 57)
or Query
None Command only.
Forces the firmware to clear the Stored Statistics log.
Note: This command takes no arguments.
6 bytes Command or Query.
Sets or returns the CnC Sweep Frequency in the form xx.xxx, where:
xx.xxx = Frequency value in the range from 0 to 60.000 kHz
Example: <0001/CCF=60.000{CR}{LF}
6 bytes Query only.
When CnC is enabled and locked, returns the delay of the interferer is
readable in microseconds.
Example 1: >0001/CDM=229500{CR}{LF} (229.5 µs)
Example 2: >0001/CDM=999999{CR}{LF} (not locked or CnC not
enabled)
6 bytes Query only.
When CnC is enabled and locked, returns the estimated frequency
offset between the desired signal and the interferer is readable in
kHz.
Example 1: >0001/CFM=+001.0{CR}{LF} (1 kHz)
Example 2: >0001/CFM=9999.9{CR}{LF} (not locked or CnC not
enabled)
Description of Arguments
10–33
SLM-5650A Satellite Modem
Revision 10
Target-to-Controller
Response to Query
Response to
(see Description of
Command
Arguments)
CAS= N/A
CAS?
CAS*
CAS#
CCF= CCF=xx.xxx
CCF?
CCF*
CCF#
N/A CDM=xxxxxx
N/A CFM=xxxx.x
MN-SLM-5650A