Comtech EF Data SLM-5650A Installation And Operation Manual page 140

(CONFIG:) Remote  EthernetConfig  SNMP  Traps  Address #1/#2
SNMP Traps IP Address #X:
000.000.000.000
Where X indicates IP Address #1 or IP Address #2:
To edit the SNMP Trap Destination IP Address: Use the arrow keys to select a digit,
and then use the  arrow keys to change that digit. Press [ENT].
CONFIG:) Remote  EthernetConfig  SNMP  Traps  Port
SNMP Trap Port:00164
To edit the SNMP Trap Port: Use the  arrow keys to select a digit, and then use the
arrow keys to change that digit.
(CONFIG:) Remote  EthernetConfig  SNMP  Traps  Community
SNMP Trap Community:
comtech
To edit the SNMP Trap Community string: Use the  arrow keys to select a character,
and then use the arrow keys to change that character.
•
Only the first 20 characters on the bottom line are available.
•
All printable ASCII characters are available with the exception of the backslash '/'
(ASCII code 92) and tilde '~' (ASCII code 126).
Once you compose the string, press [ENT]. All trailing spaces are removed from the SNMP
Trap Community string upon entry.
Front Panel Operation
To disable the Traps, set both Trap IP Addresses to
000.000.000.000
If you are running Base Firmware Version 1.4.8c or higher, you
must make sure to only use port values that are not already in
use by other services. The standard port value is 164.
(E)
7–34
SLM-5650A Satellite Modem
Revision 10
MN-SLM-5650A