Comtech EF Data SLM-5650A Installation And Operation Manual page 224

10.3.5 Modem (Unit) Commands and Queries
Controller-to-Target
Instruction Code and
Qualifier
Parameter
Type
Command Query
CnC-APC Bit N/A ABE?
Error Rate
CnC-APC BER ABR= N/A
Reset
CnC-APC N/A AFE?
Frame Error
Rate
CnC-APC FER AFR= N/A
Reset
Serial Remote Control
Arguments
for Command
(Note that all arguments are ASCII numeric codes from 48 to 57)
or Query
4 bytes Query only.
Returns the value of CnC-APC BER in the form xE-c, where:
x = value
E-c = Exponent
BER is measured in frame UW
Note: Returns 9999 if modem is not in CnC-APC mode or there is an
APC frame sync error.
Example: >0001/ABE=8E-5{CR}{LF} (indicates CnC-APC BER is
8 x 10 )
-5
None Command only.
Forces restart of the CnC-APC BER measurement.
Note: This command takes no arguments.
4 bytes Query only.
Returns the value of CnC-APC FER in the form xE-c, where:
x = value
E-c = Exponent
Notes:
BER is measured in frame UW
Returns 9999 if modem is not in CnC-APC mode or there is an APC
frame sync error.
Example: >0001/AFE=8E-5{CR}{LF} (indicates CnC-APC FER is 8 x
10 )
-5
None Command only.
Forces restart of the CnC-APC FER measurement.
Note: This command takes no arguments..
Description of Arguments
10–30
SLM-5650A Satellite Modem
Revision 10
Target-to-Controller
Response to Query
Response to
(see Description of
Command
Arguments)
N/A ABE=xE-c
ABR= N/A
ABR?
ABR*
ABR#
N/A AFE=xE-c
AFR= N/A
AFR?
AFR*
AFR#
MN-SLM-5650A